Serial ATA Cables Serial ATA or SATA has been designed as a replacement for the existing 40 way IDE cable, the SATA connector and cable are smaller (which improves air circulation), with a reduced operating voltage and pin count, 7 as opposed to 40. The current data transfer rate is ATA150, 1.5Gbps.
Each connected SATA device or conversion require's it's own cable. This removes the old master, slave setup and allows for improved data transmissions and access speed.
All our SATA cables are- Serial ATA 1.0 compliant
- Upto 1.5Gbps, ATA150
- Connect any Serial ATA drive to a motherboard or PCI card with the Serial ATA bus interface
- This and flexible, these cables free space within the PC unit and improve airflow, which reduces over heating
- Easy instillation, routing and configuration for point to point connections
- Differential signalling reduces crosstalk.
Simplifying motherboard connections while increase speeds to your storage devices with our Serial ATA cables.
These slim cables represent the latest advancement in internal interconnect technology . They enable you to line Serial ATA high speed hard drives, tape drives, optical drives and controllers.
Their slender build, which represents a department from the much wider design of traditional ribbon cables, makes them a good fit for the condensed footprint of today's machines. Instillation is a lot more easier as well.
What's more Serial ATA technology offers hot plugging capabilities and lower power consumption than older ATA interconnects.
Optimised for fast data transfers, at up yo 150 MBps, the 7 pin Serial ATA data cable depends upon low voltage differential pairs for transmitting data. Cross talk is not a worry because Serial ATA connector has shielded grounding pins within its compact head. |
|
|
SATA, eSATA adapter |  |
|
 | A SATA to eSATA adapter that comes with a 5cm SATA to SATA cable. It is also ideal for use as an eSATA to SATA coupler.
Features: - Serial ATA 1.0 Specification compliant.
- Automatic Serial ATA 1.5 Gbps speed negotiation.
- ATA, ATAPI PIO mode 0 to 4.
- ATA, ATAPI Ultra DMA of transfer rate 16.7, 25, 33, 48, 66, 100, 133, and 150MBs.
- ATA, ATAPI LBA48 addressing mode associated with 2 byte sector count. Support Serial ATA hot-plug.
- Ultra low power consumption.
- Work for both AC and DC couple between the transmitter and the receiver.
- Provide specified OOB signal detection and transmission.
- Support Spread Spectrum Clocking to reduce EMI. Support Partial, Slumber power management.
- Provide adjustable TX signal amplitude and pre-emphasis level.
- Slave support.
|
|
| SATA, eSATA adapter | | £11.10 ( £9.45 excl. VAT ) | | |
|
SATA 2 to SATA 2 cable, 1M | |
|
 | A SATA 2 to a SATA 2 cable. |
|
| SATA 2 to SATA 2 cable, 1M | | £3.37 ( £2.87 excl. VAT ) | | |
| SATA 2 to SATA 2 cable, 2M | | £4.59 ( £3.91 excl. VAT ) | | |
|
SATA 1 to SATA 2 cable, 1M | |
|
 | A serial ata, sata type 1 to a sata type 2 lead. |
|
| SATA 1 to SATA 2 cable, 1M | | £4.11 ( £3.50 excl. VAT ) | | |
| SATA 1 to SATA 2 cable, 2M | | £4.99 ( £4.25 excl. VAT ) | | |
|
Serial ATA Data Cable, 0.46 M | |
|
 | A lead to connects serial hard drive, SATA to your mother board.
Please note that some Dell computers require right angled connectors. SATA with right angled connectors are here
- Serial ATA 1.0 compliant
- Up to 1.5Gbps, ATA150
- One cable per drive required
|
|
| Serial ATA Data Cable, 0.46 M | | £2.35 ( £2.00 excl. VAT ) | | |
| Serial ATA Data Cable, 0.75 M | | £2.28 ( £1.94 excl. VAT ) | | |
| Serial ATA data cable, 1M | | £2.71 ( £2.31 excl. VAT ) | | |
|
Sata 1 external cable, 1M | |
|
 | A STAT 1 cable suitable for external use.
- Serial ATA 1.0 compliant
- Up to 1.5Gbps, ATA150
- One cable per drive required
|
|
| Sata 1 external cable, 1M | | £2.81 ( £2.39 excl. VAT ) | | |
| Sata 1 external cable, 2M | | £2.80 ( £2.38 excl. VAT ) | | |
|
Serial ATA with a straight and a right angled connector, 0.5M | |
|
 | A lead with straight to a right angled 90 degrees, connectors used to connect a serial hard drive, SATA, to your mother board. Please note that some Dell computers require right angled connectors. So please check first.- Serial ATA 1.0 compliant
- Up to 1.5Gbps, ATA150
- One cable per drive required
|
|
| Serial ATA with a straight and a right angled connector, 0.5M | | £3.30 ( £2.81 excl. VAT ) | | |
| Serial ATA with a straight and a right angled connector, 1M | | £4.14 ( £3.52 excl. VAT ) | | |
|
Serial ATA data cable with right angled connectors, 0.46 M | |
|
 | A lead with right angled 90 degrees, connectors used to connect a serial hard drive, SATA, to your mother board. Please note that some Dell computers require right angled connectors. So please check first.- Serial ATA 1.0 compliant
- Up to 1.5Gbps, ATA150
- One cable per drive required
|
|
| Serial ATA data cable with right angled connectors, 0.46 M | | £1.80 ( £1.53 excl. VAT ) | | |
| Serial ATA data cable with right angled connectors, 1M | | £2.19 ( £1.86 excl. VAT ) | | |
|
Serial ATA power cable, 0.15M | |
|
 | A lead to connects serial ATA, SATA hard drives which only have the new edge connector style plug.
|
|
| Serial ATA power cable, 0.15M | | £2.09 ( £1.78 excl. VAT ) | | |
|
ATX, 5 1/4in power plug to twin serial ATA power plugs | |
|
 | 5 1/4in power plug to twin SATA power plug connections.
Works with ATX power supplies, using high quality cable and connectors
Twin serial ATA power to ATX power connection |
|
| ATX, 5 1/4in power plug to twin serial ATA power plugs | | £1.67 ( £1.42 excl. VAT ) | | |
|
SATA Combo Y lead | |
|
 | A combined power and data serial ata cable.
Power cable 0.11 M
Data cable 0,45 M |
|
| SATA Combo Y lead | | £2.21 ( £1.88 excl. VAT ) | | |
