AA3318 Broadband and telephone extension kit, 15M

Instruction

1. Locate your master socket and remove any existing ADSL
2. Insert the supplied UK, US adapter into the master socket.
3. Then run the attached extension cable to the desired location of the extension socket. Leaving a small amount of tolerance, +- 15cm, secure the cable to your wall or skirting using cable clips, evenly spaced.
4. Remove one of the snap out areas on the reverse or sides of the back box, to allow you to feed your cable through. Screw the back box to the skirting board or wall.
5. Feed the wire into the extension socket, cut the wire to the desired length and strip approximately 10 to 15mm of outer sheath from the cable. Then strip approximately 10mm of the sheath from each inner wire. Screw inner wires to connections following the colour coding:
   

   1	Not used
   2	Blue with white banding
   3	Orange with white banding
   4	White with orange banding
   5	White with blue banding
   6	Not used

6. Screw front plate onto back box.
7. Return to your master socket and plug your original ADSL filter into the adapter
8. You may now use your phone and broadband modem simultaneously at either point.

Safety Information

Before carrying out any electrical work, always switch off at the mains. If in doubt consult a qualified electrician.