AA2747 Rotary coax cable stripper suitable for RG6, RG58, RG59 type or equivalent

Instructions

Stripping Length

This stripper can strip cable in four lengths 4, 6, 8 and 12mm, you may adjust
the blades position.

Blades Depth

You may use the hex wrench, which is installed on the bottom of the tool to
adjust the blades depth. Insert the hex wrench into the blade depth adjuster on the bottom of the stripper. The rotate the hex wench clockwise, to cut smaller
cable or counter clockwise, to cut larger cable. Repeat above steps to set the other blade.

Stripping Cable

1. The V block is reversible. Use the hex wrench to push the V block out of the
   housing. Align the character on the V block with the arrow. Then insert the V block into its housing. The indicated arrow recommended the RG cable size mark in the front of the V block. 6 = RG6, 5C2V, 8 = RG58, 3C2V, 9 = RG59, 62.
2. Press the knurled portion on the upper jaw to open the strippers jaw.
3. Insert the cable you want to strip through the V block until the cable reaches
   the V shaped cable guide. Then release the upper jaw to close the jaws.
4. Insert your index finger into the strippers finger ring, turn the stripper
   clockwise 1 to 4 times. The cables insulation is cut while you turn the stripper.
5. Open the jaws and remove the cable. Pull away the outer jacket and dielectric to expose the inner conductor.